Na}{

File Content: `README.Debian`

ethtool for Debian
------------------

Most settings that can be controlled through ethtool can be specified
in /etc/network/interfaces.  They will then be applied to interfaces
that are brought up automatically at boot time or using the 'ifup'
command.  The following settings are supported:

Link mode (--change):
	link-speed <speed>
	link-duplex half|full

Ethernet settings (--change):
	ethernet-autoneg on|off|<mask>
	ethernet-port <port>
	ethernet-wol <mode> [<pass-key>]

Driver control (--change):
	driver-message-level <level>

Ethernet flow control (--pause):
	ethernet-pause-rx on|off
	ethernet-pause-tx on|off
	ethernet-pause-autoneg on|off

Protocol offload (--offload):
	offload-rx on|off
	offload-tx on|off
	offload-sg on|off
	offload-tso on|off
	offload-ufo on|off
	offload-gso on|off
	offload-lro on|off
	(etc.)

Hardware tuning (--coalesce, --ring):
	hardware-irq-coalesce-adaptive-rx on|off
	hardware-irq-coalesce-adaptive-tx on|off
	hardware-irq-coalesce-rx-usecs <n>
	hardware-irq-coalesce-rx-frames <n>
	(etc.)
	hardware-dma-ring-rx <size>
	hardware-dma-ring-rx-mini <size>
	hardware-dma-ring-rx-jumbo <size>
	hardware-dma-ring-tx <size>

Example:

iface eth0 inet dhcp
	link-speed 100
	link-duplex full
	ethernet-autoneg off
	ethernet-wol s 46:65:62:69:61:6e

 -- Ben Hutchings <ben@decadent.org.uk>, Sat,  4 Jun 2011 20:37:08 +0100

Name	Size	Permission
AUTHORS	296 bytes	0644
NEWS.gz	8678 bytes	0644
README	127 bytes	0644
README.Debian	1356 bytes	0644
changelog.Debian.gz	1563 bytes	0644
copyright	4547 bytes	0644

File Content: README.Debian

File Content: `README.Debian`